Taurus Optima Manuel D'instructions page 22

Use and care:
- Fully unroll the appliance's power cable
before each use.
- Do not use the appliance if the parts or
accessories are not properly fitted.
- Do not use the appliance if it is empty.
- Do not use the appliance if the on/off switch
does not work.
- Do not turn the appliance over while it is in
use or connected to the mains.
- Do not overload the appliance's weight
capacity.
- Disconnect the appliance from the mains
when not in use and before undertaking any
cleaning task
- This appliance is for household use only, not
professional, industrial use.
- This appliance is intended for adult use.
Ensure that this product is not used by the
disabled, children or people unused to its
handling.
-During emptying and cleaning the jar, take
care on handling the sharp cutting blades.
- This appliance is not a toy. Children should
be supervised to ensure that they do not play
with the appliance.
- This appliance should be stored out of reach
of children and/or the disabled.
- Keep the appliance in good condition. Check
that the moving parts are not misaligned or
jammed and make sure there are no broken
parts or anomalies that may prevent the
appliance from operating correctly.
- Never leave the appliance connected and
unattended if is not in use. This saves energy
and prolongs the life of the appliance.
-Do not forget to place the sealing ring on the
blade unit . Otherwise, leakage may occur.
All manuals and user guides at all-guides.com
-Do not run the jar blender for more than 2
minutes at a time. Do not run the mill for more
than 20 seconds at a time (*). If the motor unit
is overheated, switch off and cool down the
appliance before you let it run again.
-This product is not designed to cater hot
liquid. Please do not mix hot liquid in the jar
blender.
-To crush ice cubes, put no more than 4 ice
cubes at one time. If you wish to add more
ice, pull out the measuring cup and insert the
ice cubes consecutively.
Use:
-Fit the jar onto the motor body.
-Put the ingredients, after having first chopped
them into small piece, into the jar with liquid
(do not exceed the maximum marker)
-Put the measuring cup in the lid.
-Put the lid on the jar, make sure it is properly
fixed in place.
-Ensure the blade fixing ring is fixed properly
to the jar (by turning counter clockwise)
before putting on the motor body. (Fig.1)
-Place the jar onto to the motor unit, turn
clockwise until the lock clicks into place.
(Fig.2)
-Connect the appliance to the mains.
- Choose desired speed and start blending.
-If you wish to add more ingredients pull out
the measuring cup
-Add the ingredients and replace the
measuring cup.
-To stop the appliance set the speed back
to "0".
Instructions for use