Caple CR700 Manuel D'instructions page 16

WORKING
Remote control (Fig.11)
channel radio control for cooker hood
remote.
At first ignition, keep pressed the lighting
button for 5 seconds.
RC001
R C
ADIO
ONTROL
Radio control used for the remote operation
of ducted cooker hoods.
TECHNICAL DATA
- Alkaline battery powered: 12 V mod. 23 A
- Operating frequency: 433.92 Mhz
- Combinations: 32.768
- Max. consumption: 25 mA
- Operating temperature: -20 ÷ + 55 °C
- Dimensions: 120 x 45 x 15 mm.
OPERATING DESCRIPTION
The transmitter is equipped with 5 buttons
for cooker hood management, as specified
below:
: Light ON/OFF command.
: Motor ON (speed level 1) / OFF command.
: Reduce speed.
: Increase speed.
: 10-minute timer.
The set extraction speed is indicated by the
LED in the extraction perimeter channel.
To each color generated by the LED, it
corresponds a specific speed, as shown
below: First speed WHITE
Second speed BLUE
Third speed DARK BLUE
Fourth speed RED
INITIAL OPERATING CONDITION
The manufacturer supplies the radio control
unit ready to be used with codes preset in the
Factory
All manuals and user guides at all-guides.com
OPERATION MODE
Standard configuration:
Standard
"cooker hoods radio control system" to be
provided
code.
radio control system are installed in the
same room or nearby, each system may
affect
Therefore, the code of one radio control
system must be changed.
Generating a new transmission code:
The radio control system is provided with
preset
required,
simultaneously buttons:
for two seconds. When Leds light on, press
buttons:
(within 5 seconds). Leds flashing 3 times
indicate the procedure is completed.
WARNING! This operation deletes
permanently the preset codes.
Learning the new transmission code:
Once the transmission code is changed in
the radio control unit, the electronic central
unit of the cooker hood must be made to
set the new code in the following way:
Press the main power-off button of the
hood and then restore power to the
electronic control unit. Within the next 15
seconds, press the Light Button
synchronise the central unit with the code.
Reset of the Factory configuration:
To restore the Factory configuration, follow
the
simultaneously buttons:
for 2 seconds. When Leds light on, press
buttons:
16
configuration
with the same
In the event two cooker hoods
the operation of
codes. Should
proceed as
procedure described
requires all
transmission
the another.
new codes be
follows: Press
to
below: press