ANSMANN FL800AC Traduction De La Notice Originale page 7

• To avoid hazards, the flexible exterior cord of this
floodlight, if damaged, may only be replaced by
the manufacturer, its service representative or a
comparable professional.
This product complies with protection class I
and must therefore be connected to the
protective earth conductor.
Do not look directly into the beam of light.
Do not shine the light in the faces of others.
Looking into the beam of light for too long
may cause damage to the retina due to blue
light.
The safety glass is non-
replaceable. If the safety glass is
damaged, dispose of the product.
• Safe operation cannot be guaranteed if the
product shows any kind of damage. If the product
is damaged, it must be disposed of or repaired.
• Do not repair the product yourself! Have repairs
carried out by a professional electrician.
m Caution: The light source of this luminaire is not
replaceable. When the light source reaches its
end of life the whole luminaire shall be replaced.
m Warning: Fire hazard! Do not cover the product
during operation and keep it away from
inflammable surfaces.
All manuals and user guides at all-guides.com
Deutsch | English | Français | Español | Português
Svenska | Italiano | Nederlands | Suomi | Norsk | Dansk
PRODUCT DESCRIPTION
(see page 2)
1 LEDs
2 Handle
3 Set screws
4 Power cord with
power plug
SETUP INSTRUCTIONS
• Always carry the product by the handle.
• Always set up the product on the stand.
• Always suspend the product by the suspension
eyelet.
• The joints have some resistance to prevent
unintentional adjustments. Adjust the angle of
the stand slowly, avoid jerky movements.
SETTING THE FLOODLIGHT
• Loosen both set screws.
• Adjust the angle of the floodlight.
• Re-tighten the set screws.
STARTING OPERATION
The product does not have a switch. It is turned on
and off directly via the power supply.
• Turn on: Plug the power plug into a suitable power
outlet.
• Turn off: Disconnect the power plug from the
power outlet.
CLEANING
• Always disconnect the power supply before
cleaning the product.
• Use only a soft, dry or slightly damp cloth
(where necessary with a little mild dishwashing
detergent) to clean the product. Never use
any abrasive cleaners or solvents to clean the
product.
5 Suspension eyelet
6 Stand
7 Joints
7