Orbegozo RO 1010 C Manuel D'instructions page 14

RO 1010 C
NOTE: This heater is oil filled and will cool down slowly after the power is switched off. Allow
the heater to cool down before moving and always use the built-in handle
CLEANING YOUR OIL RADIATOR
1. Always disconnect the heater from the mains supply before cleaning.
2. Clean the outside of the heater by wiping with a damp cloth and buff with a dry cloth.
3. DO NOT use waxes or polishes as these may react with the heater and cause discolouration.
STORING YOUR OIL RADIATOR
1. Save the box for off season storage.
2. Clean the heater following the cleaning instructions above.
3. Remove the wheel base assemblies.
4. Place the radiator, and wheel assemblies in the original box, and store in a cool and dry place.
5. If you choose to store your heater fully assembled, be sure to cover it to protect it from dust.
Disposal of old electrical appliances.
The European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE), requires
that old household electrical appliances must not be disposed of in the normal unsorted
municipal waste stream. Old appliances must be collected separately in order to optimize the
recovery and recycling of the materials they contain, and reduce the impact on human health and
the environment.
The crossed out "wheeled bin" symbol on the product reminds you of your obligation, that when
you dispose of the appliance, it must be separately collected.
Consumers should contact their local authority or retailer for information concerning the correct disposal of
their old appliance.
DECLARATION OF CONFORMITY:
This device complies with the requirements of the Low Voltage Directive 2014/35/EU and the
requirements of the EMC directive 2014/30/EU.
This product is only suitable for well insulated spaces or occasional use
Item RO 1010 C Symbol
Heat output
All manuals and user guides at all-guides.com
Value Unit Item RO 1010 C
Type of heat input, for electric storage local space heaters only
Unit
14