Publicité
7. Slide control rod crank through hole in handle panel and
into control rod universal joint (P).
8. Secure with hair pin (Q).
Q
8
4
All manuals and user guides at all-guides.com
9. Visually check for gear mesh between worm and ring
10. Loosen the adjustment nut (S).
11. Slide the worm gear assembly closer to or farther from
12. Tighten the adjustment nut to 15 lb-ft (20 Nm) (U).
P
7
13. Install gear assembly cover and tighten nut securely (V).
gears. There should be a small amount of backlash to
prevent binding (R).
the ring gear until there is a small amount of gap between
the gear teeth (T).
15 lb-ft
U
12
(20 Nm)
1/2˝
T
11
V
13
S
10
R
9
Publicité
