Publicité
Les langues disponibles
Les langues disponibles
Operation
D. Top Light Dimmer Control
The top Top Light Dimmer Control
controls the brightness of the top
accent light that is used to illumi-
nate the pebbles.
Resetting The Temperature
Cutoff Switch
Should the heater overheat, an
automatic cut out will turn the fire-
place off and it will not come back
on without being reset. It can be
reset by switching the 3-Position
Switch to OFF and waiting five
minutes before switching the unit
back on.
CAUTION: If you need to
continuously reset the heater,
disconnect power and call
Dimplex customer service at
1-888-DIMPLEX
(1-888-346-7539).
Remote Control
The fireplace is supplied with an
integrated on/off remote control
!
NOTE: Ensure that the fire-
place 3-Position Switch is set
to the remote control setting.
To operate, push the ON button
to turn fireplace on, push the OFF
button to turn the fireplace off.
!
NOTE: Before attempting any
operation with the remote control,
All manuals and user guides at all-guides.com
pull the plastic insulator strip out
from between the remote casing
and battery cover.
Remote Control Initialization/
Reprogramming
15. Disconnect power to fire-
16. Wait a minimum of 5 seconds
17. Within 10 seconds of re-
This will synchronize the remote
control and receiver.
Battery Replacement (Figure 11)
To replace the battery:
1. Slide battery cover open on
Figure 11
place.
and then re-acquire power to
fireplace.
acquiring power, press the On
button located on the remote
control.
the remote control.
On
Button
Off
Button
Plastic
strip
Battery
cover
15
Publicité
