Videotec HTV Manuel D'instructions page 12

7 Accessories
For further details on configuration and
use, refer to the relative manual.
7.1 Heater
7.1.1 Heater installation
Open the housing as described in the relative chapter
(6.1 Housing opening, page 7).
Fix the heater kit to the prearranged points on the
body of the housing.
The pre-wired heating element (01) should be
positioned between the 2 dissipators (02) before
attachment to ensure contact and hence guarantee
correct heat transmission.
Pass the heating wiring under the slide to fix the
camera.
01
Fig. 6
At the end of istallation, connect the wiring to
the terminal (power supply connector, 6.3 Board
description, page 8).
Reposition the internal slide and tighten the screws
that had been loosened previously.
10
7.2 Camera power supply
7.2.1 Camera power supply installation
Usable power supplies:
• IN from 100Vac up to 240Vac, 50/60Hz - OUT
12Vdc, 1.25A
• IN 230Vac, 50Hz - OUT 24Vac, 50Hz, 400mA
Fig. 7
02
02
Not usable in housings with wiper device
installed.
Pay attention to the voltage used to power
the circuit. Depending on requirements use
the correct power supply kit.
Camera power supply.
MNVCHTV32_2104_EN