Videotec HTV Manuel D'instructions page 10

6.3 Board description
The board may appear different to that
illustrated.
Depending on the product version, the
board may not be equipped with all
functions.
BOARD DESCRIPTION
Connector Function
J1 Power supply for the board (V
J2 Auxiliary output (V
J3 Heater power supply (V
J4 Tamper switch contacts3
J5 Camera power supply (V
J7 Power supply connector/jumper5
J8 Fan power supply (V
SW1 Tamper switch3
Tab. 1 From 100Vac a 240Vac, 24Vac o12Vdc.
1
Same voltage applied to power supply terminal of the
2
board (J1).
Optional.
3
Different alternatives are available depending on the
4
version. V = 12Vdc o V
OUT
type of power supply installed (7.2.1 Camera power
supply installation, page 10). V
sings powered in 12Vdc or 24Vac, with jumper inserted
(J7).
To install a power supply in 12Vdc or 24Vac refer to the
5
relative chapter (7.2.1 Camera power supply installa-
tion, page 10).
J8
SW1 J7
Fig. 3
Nominal section of the cables used: from
0.2mm² (24AWG) up to 2.5mm² (13AWG).
8
)1
IN
)2
OUT
)
OUT
)4
OUT
)
OUT
= 24Vac, in relation to the
OUT
= V , only for hou-
OUT IN
J2 J1 J4
J3 J5
6.4 Connection of the power
supply line
CAUTION! The type of cable used must be
compatible with the planned use. Comply
with the national regulations in force on
electrical installation.
Connect the safety earth to the relative
terminal of the J1 connector.
Earth cable should be about 10mm longer
than the other two, so that it will not be
disconnected accidentally if pulled.
Insert the cables inside the housing using the cable
glands. The cable glands are suitable for conductors
with diameters of between 5mm and 10mm. The
section of the cable inside the housing must be
sufficiently long to allow connection. Suitably lock
the cable glands.
Remove the conductors protective sheathing and
connect them to terminal (J1, 6.3 Board description,
page 8).
MNVCHTV32_2104_EN