Publicité
Les langues disponibles
Les langues disponibles
❶
ON
ON
1
2
3
1
4
2
SW4
C
❶
ON
ON
1
2
3
1
4
2
SW4
D
Stand-alone programming in SLAVE mode
VA/08
ETI/XIP
ETI/XIP APP
DVC/IP
RFID
PROG
+
❶
Ð
A
RFID
PROG
+
Ð
B
RFID
❶
PROG
+
Ð
C
M2
ON
1
SW4
❷
+
3
4
beep
ON
1
SW4
❷
SW2
MASTER
+
3
4
beep
SW2
SLAVE
ON
SW4
PROG
❷
beep
❸
Swipe the badges to be associated. A tone will confirm that the association has taken
place A❸; 3 quick tones will indicate an error condition.
PROG
At the end, reposition the RFID PROG jumper in the rest position. The PROG LED on the
power supply and the red LED on the reader go off B.
SW2
SLAVE
M3
ON
1
SW4
❷
PROG
beep
❸
M3
2
3
4
To remove lost badges, set DIP4 to ON C❶, The red LED will
remain on and steady C❷.
Pass all the badges previously acquired close to the reader C❸.
At the end, set DIP4 back to OFF: the red LED will go off D.
❸
A tone will confirm the removal of the badges programmed previ-
ously but not acquired in the phase, otherwise 3 quick tones will
2
3
4
indicate an error condition.
N.B.
- In order for the procedure to be valid, you must pass at
least one previously acquired badge.
1
2
3
4
Adding badges with VA/08
Set the RFID PROG jumper on the power supply to "+" A❶.
The red LED on the RFID will flash quickly A❷.
2
3
4
Removing badges with VA/08
Set the RFID PROG jumper on the power supply to "-" C❶. The
red LED on the RFID will flash slowly C❷.
Swipe the badges to be removed twice. A tone will confirm that
the removal has taken place C❸; 3 quick tones will indicate
an error condition.
At the end, reposition the RFID PROG jumper in the rest position.
The PROG LED on the power supply and the red LED on the
reader go off B.
Publicité
