Arcam DV78 Manuel page 12

Using the CR-314 remote control
Ensure that DVD mode is selected using the
toggle button. The 'DVD' LED above the
is lit briefly when DVD mode is selected.
Dims or turns the DV78's display on or off. Turning the display off
generally gives a slight improvement in sound quality.
Pressing once turns the display off; twice dims the display.
DISP
To restore the display to full brightness, press
This button enables you to repeat a selected
section from the disc (see page 16).
Press to cycle through the repeat play options.
RPT
Fast play and Skip chapter/tracks
Play fast ( ) and Skip (
Opens and closes the disc tray.
Pause ( ), Play ( ) and Stop ( ) (see page 11).
These buttons are described on the facing page.
DV78
12
All manuals and user guides at all-guides.com
CD/DVD
CD/DVD
CD/DVD button
DISP (display)
CD
a third time.
DISP
CD
DVD
A–B
DISP
A-B
RPT (repeat)
RPT
) chapters/tracks in both
directions (see page 11).
OPEN
Playback control
P
MODE
Advanced controls
ZOOM
ANGLE
0–9 keypad
This allows direct access to individual tracks on audio CDs. To
select a track, press the corresponding keypad button followed
by . For tracks greater than 9, enter the digits in sequence.
OK
For example, to play track 15, press
Standby
Press
Note that Arcam CD players are not controlled by this button.
CD/DVD
DVD
CLEAR
1 2 3
Use CLEAR
a numeric field (see pages 16–17).
4 5 6
PROG (program)
7 8 9
You can program a selection of up to 20 chapters/tracks
from a disc to play in any order. Press
0 'Programme' menu (see pages 17 and 19).
CLEAR PROG
Slow play
Press
backwards. There are four speeds of slow playback: 1/5,
1/4, 1/3 and 1/2. Press the button repeatedly to cycle
through the different speeds. To resume normal playback
speed, press
OK
OPEN
Note that slow play does not apply to audio CDs.
Cursor pad and OK button
Use the cursor pad to navigate the On Screen Display (OSD) and
menu pages. Confirm your selection with the
MUTE
Stops sound to the speaker outputs of certain Arcam amplifiers.
Volume +/–
Adjusts the volume on Arcam remote-controllable amplifiers.
Note that the volume (+/–) controls and
no effect on the audio output level of the DVD players.
SUBT TITLE MENU
AUDIO MEM RTN
SETUP STATUS SRCH
CR-314
NOTE: Remember to install the two AAA batteries supplied
before trying to use your remote control.
Do not place anything in front of the display area on the
DVD player (where the IR receiver is located), or the
remote control may not work.
1 , then 5 , then OK
Standby to toggle the standby state of the DVD player.
within the 'Program' and 'Bookmark' menus to clear
PROG
or on the remote control to play slow forward or
.
PLAY
MUTE
.
to access the
button.
OK
button have