Publicité
Les langues disponibles
Les langues disponibles
Installing an expansion card
1.
Remove the metal cover
opposite the slot that you
intend to use.
Installing an optical drive
1.
Drive a screw on the top right
screw hole on both sides of
the drive.
3.
Push the drive all the way into
the bay until the drive lock clicks.
4.
Connect a 4-pin power plug
from the power supply unit to
the power connector at the
back of the drive.
Installing a SATA hard disk drive
1.
Drive two screws with rubber
washers on both sides of the
drive.
R u b b e r w a s h e r
R u b b e r w a s h e r
R u b b e r w a s h e r
R u b b e r w a s h e r
R u b b e r w a s h e r
2.
2.
2.
P o w e r c a b l e
P o w e r c a b l e
P o w e r c a b l e
P o w e r c a b l e
P o w e r c a b l e
a n d p l u g
a n d p l u g
a n d p l u g
a n d p l u g
a n d p l u g
S i g n a l c a b l e
S i g n a l c a b l e
S i g n a l c a b l e
S i g n a l c a b l e
S i g n a l c a b l e
a n d p l u g
a n d p l u g
a n d p l u g
a n d p l u g
a n d p l u g
Q u i c k I n s t a l l a t i o n G u i d e
Q u i c k I n s t a l l a t i o n G u i d e
Q u i c k I n s t a l l a t i o n G u i d e
Q u i c k I n s t a l l a t i o n G u i d e
Q u i c k I n s t a l l a t i o n G u i d e
Insert the card connector to
the slot, then press the card
firmly until it fits in place.
Connect the IDE and audio
cable at the back of the drive.
Connect the SATA signal and
power plug at the back of the
drive.
7 7 7 7 7
Publicité
