clage Zip HydroTap G5 BCS 60 Instructions D'utilisation Et D'installation page 27

4. Installation
Socket
O-Ring
Rubber
Locking
seal
washer
Nut
Triple silicone tube
Herbie hose clamp
Boiling Steam
water
Socket
O-Ring
Rubber seal
Locking washer
Triple silicone tube
Quick connector
Flexible hose
warm water (red)
Flexible hose for
mixed water
Flexible hose for
ambient water (blue)
Nut
Triple silicone tube
Boiling water
Steam
plate with the fastening nut. Check the tap head is in the correct position before
tightening up the nut.
Pay attention to the correct position of the O-ring at the socket.
Install hose set
1. Slide the Herbie hose clamp from below onto the triple-silicone tube.
Do not close the clamp yet!
2. Connect the blue and white plastic tubing to the quick connectors of the chilled and
sparkling connector and push the flattened side of the connector approx. 20 mm
into one of the side openings of the triple silicone tube.
The flat surface must be aligned to the steam line.
3. Slide the red silicone hose onto the round end of the boiling connector and push the
flattened side of the connector approximately 20 mm into the other side opening of
the triple silicone tube.
The flat surface must be aligned to the steam line.
Cold water
4. Position the Herbie hose clamp as close as possible to the end of the triple silicone
+ sparkling
tube and close it by pressing with a pair of pliers.
water
Note: For maximum grip on all three connectors, ensure the Herbie hose clamp is
aligned axial to the silicone tube.
Installation Celsius
Note: The tap must not be installed more than 900 mm above the base of the
undersink unit. Failure to do this may result in poor water delivery.
1. Make sure that the tap location will allow water from the tap to fall into a sink or
other basin fitted with a drain to drain away.
2. Cut a 50 mm diameter hole in the worktop / sink at the place where the tap is to be
installed.
3. Pass the hoses down through the 50 mm hole in the worktop / sink and locate the
tap head on its mounting location.
4. From the underside, push first the rubber seal and the sluice plate over the
hoses / cables, then over the threaded rod of the tap fitting. Secure the sluice
plate with the fastening nut. Check the tap head is in the correct position before
tightening up the nut.
Pay attention to the correct position of the O-ring at the socket.
5. Install the flexible hoses for warm, ambient and mixed water according to the
drawing (see left).
6. Connect the cold water connector of the triple silicone tube to the supplied quick
connector and Y adapter.
7. Push the blue and white plastic tubes as far as they will go into the two openings
of the Y adapter.
Cold water &
sparkling water
27
CLAGE
EN