Publicité
Les langues disponibles
Les langues disponibles
To select the right speed for each job, use practice piece of material.
SLIDE "ON/OFF" SWITCH
The tool is switched "ON" by the slide switch located on the topside of the motor housing.
TO TURN THE TOOL "ON", slide the switch button forward. The tool will start working
at a speed of 15,000 rpm
TO TURN THE TOOL "OFF", slide the switch button backward. If for some reasons the
on/off switch doesn't work there is always the option to alternatively turn off the tool by the following methods:
Press decrease speed control button(G2) to bring the speed of the tool to the lowest speed level (5,000 RPM).
Hold decrease speed control button(G2) for 5 seconds. Then the tool will be turned off.
SPEED CONTROL BUTTONS
The tool is equipped with speed control buttons. The speed may be adjusted during operation by pressing on increase or decrease buttons located
on the topside of the battery housing. Speed will increment or decrement from a minimum of 5,000 to a maximum of 25,000 rpm. The LED lights
will illuminate according to the chosen speed. Every time the tool is turned off the speed set goes back to the medium level (15,000 rpm) so it might
be necessary to increase/decrease the speed to the level that it was being used(Figure 4).
The speed of Rotary Tool is controlled by setting the blue speed control buttons.
Settings for Approximate Revolutions
Speed Setting
1
2
3
4
5
Operating Speeds
Speed Range
5,000 RPM
10,000 RPM
15,000 RPM
20,000 RPM
25,000 RPM
- 13 -
Fig.4
Publicité
