Installation Preparation
Questions? Call 844-GE4-PTAC (or 844-434-7822 ) or
BEFORE YOU BEGIN
Read these instructions completely and carefully.
IMPORTANT –
•
instructions for local inspector's use.
IMPORTANT –
•
codes and ordinances.
Note to Installer –
•
instructions with the owner.
Note to Owner –
•
future reference.
•
shall not be accessible to the general public.
•
covered under the Warranty.
•
•
installation procedures as described in these
instructions when installing this air conditioner.
IMPORTANT ELECTRICAL
SAFETY—READ
CAREFULLY
WARNING
RISK OF ELECTRIC SHOCK.
installed by a qualified electrician.
local codes and ordinances.
must be properly grounded.
the nameplate of each unit.
• Do not use an extension cord with this unit.
• Aluminum building wiring may present special
problems—consult a qualified electrician.
• When the unit is not running there is still voltage to
the electrical controls.
• Disconnect the power to the unit before servicing by:
circuit breakers off at the panel.
2. Disconnecting the power cord from the unit.
Save these
Observe all governing
Be sure to leave these
Keep these instructions for
Visit our Website at:
ELECTRICAL
REQUIREMENTS
Use ONLY
for single outlet branch circuit
Fuse/Circuit
Breaker
current protection to the units is the
responsibility of the owner.
Grounding
circuit to unit, or through separate
ground wire provided on permanently
connected units. Be sure that branch
circuit is grounded.
in tables and install a single branch
circuit. All wiring must comply with
local and national codes.
NOTE: Use copper conductors
only.
NOTE: All field wiring must comply with NEC and
local codes. It is the responsibility of the installer
to ensure that the electrical codes are met.
outlet branch circuit.
of the owner.
Recommended Branch Circuit Wire Sizes*
Nameplate
Maximum Circuit
Breaker Size
AWG - American Wire Gauge
C
NOTE: Use copper conductors only.
WARNING
RISK OF ELECTRIC SHOCK.
properly grounded.
GEAppliances.com
AWG Wire Size**
49-5000640 Rev. 1