Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
TROUBLESHOOTING
CAUTION! Switch off and remove plug from mains before investigating fault.
Conventional trouble
Motor does not start.
The machine vibrates or shakes.
Saw blade (6) binds, jams, burns
wood.
Rough cuts.
Cannot move miter adjustment.
If the problem cannot be remedied on the basis of the information above, please take the device to an authorized
IVT Service Center.
ATTENTION! DO NOT ATTEMPT TO REPAIR THE PRODUCT BY YOURSELF AND DO NOT
TAMPER WITH IT! Any operation of repairing or extraordinary maintenance must be carried
out only by a qualified and authorized IVT Service Center. Do not try to modify any internal
part of the product! THIS WILL COMPLETELY VOID THE WARRANTY AND IT COULD CAUSE
SERIOUS INJURY AND DAMAGE.
Trouble reason
∙
Unit isn't plugged in.
∙
Carbon brushes are worn.
∙
Saw blade (6) not round.
∙
Saw blade (6) damaged.
∙
Saw blade (6) loose.
∙
Dull or improper saw blade (6).
∙
Bent saw blade (6).
∙
Miter
locking
knob
tightened / detent engaged.
∙
Sawdust under table.
13
Instruction manual
Remedy
∙
Plug unit in.
∙
Replace carbon brushes.
∙
Replace saw blade (6).
∙
Replace saw blade (6).
∙
Tighten blade screw.
∙
Replace saw blade (6).
∙
Replace saw blade (6).
(19)
∙
Loosen miter locking knob (19)
/ move out of detent.
∙
Vacuum or blow out dust.
EN
Publicité
