4. Removing Memory Cards
To remove a memory card inserted into the camera, remove the silicone cover (see step 1 on chapter 3), then press
the centre of the memory card in and release it slowly. The memory card can then be removed by hand.
* The memory card can be removed whether the camera is on or off.
* Make sure the camera is dry and use dry hands..
* When done, remember to close the silicone cover (see step 3, chapter 3)to prevent dust or water from
entering and damaging the camera.
5. Charging the Camera
The camera contains an integrated rechargeable battery. The camera is fully charged at shipment. As the camera
gradually loses its charge when not in use, charge it before use. The camera charges the battery internally.
* For this section, make sure the camera is dry and use dry hands.
Plug the USB-A end of the included USB cable into any USB-A charging port, such as on a computer, power bank,
or wall charger. Then remove the silicone cover (see step 1 on chapter 3) and connect the other end of the cable
to the camera's Micro-B USB port.
* Make sure the cable's connectors are in the correct orientation before they are inserted and the connectors
are inserted fully.
When the camera is connected as above, the LCD screen shows the following icon on a white background:
When the camera is charging, a blinking red charging icon appears on the bottom left hand corner of the LCD
screen. When charging is complete, this icon is replaced by a non-blinking green battery icon.
* Charging times vary depending on ambient temperature.
* When charging is complete, carefully disconnect the cable from the camera and the camera automatically
turns off. Then close the silicone cover (step 3 on chapter 3) to prevent dust or water from entering and
damaging the camera
6. Vérification du niveau de la batterie
After turning the camera on (see chapter 7), check the battery level on the bottom left hand corner of the LCD
screen.
The 5 different battery levels are shown as follows:
In order from right to left:
100% – 80%
080% – 60%
060% – 40%
040% – 20%
020% – 00% (charge the camera)
EN-20200831