Publicité
Les langues disponibles
Les langues disponibles
Phase 3 | Beam Assembly
(If there is power block option selected, recommend to install it
to beam first before assembling the beam to frame.) See Phase 6
for power block assembly.
2
Step 1
Adjust stretcher frame depending on the beam
length selected. Make sure the middle stretcher
bar is positioned right in the middle by using the
marking guides indicated on it.
Step 2
Slot beam into column bracket as in diagram
below.
Step 3
Screw in M10*22 screws to secure beam from
the front.
Kinex Installation Guide | 12
1
5
5
Step 4
Screw in M6*10 screws to secure the beam from
the sides.
Step 5
Tighten all 8 pre-installed socket screws to secure
the stretcher frame.
3
amqsolutions.com
Kinex Single Run
4
Publicité
