Agri-Alert KPB 400 Installation page 2

MOUNTING THE UNIT
Open the KPB-400 by pulling on the latch below the enclosure. Mount the enclosure
on the wall using 3/16" diameter screws.
Mounting Holes:
CONNECTIONS
All wires are connected to the main card inside the enclosure. Strip the wires as little
as possible (about 1/4") to avoid electrical shorts when connecting the equipment to
the terminals provided. Once the wires are connected, run them through the electri-
cal knockouts provided on the bottom of the enclosure and use a cable holder.
Additional holes made in the enclosure will void the warranty.
CONNECTIONS
Sensors — The terminals used for sensor inputs are numbered Z1, Z2, Z3, etc. Con-
nect each sensor to a Z terminal and to a COM terminal. Each COM terminal is used
by two zones: for example, Z1 and Z2 use the same COM.
2
KPB-400.rev.04