Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Reversing switch action
A
B
1
010156
CAUTION:
Always check the direction of rotation before
•
operation.
Use the reversing switch only after the tool comes
•
to a complete stop. Changing the direction of
rotation before the tool stops may damage the tool.
When you operate the tool in counterclockwise
•
rotation, the switch trigger is pulled only halfway
and
the
tool
counterclockwise rotation, you cannot push in the
lock button.
This tool has a reversing switch to change the direction
of rotation. Move the reversing switch lever to the
position (A side) for clockwise rotation or to the
position (B side) for counterclockwise rotation.
Selecting action mode
CAUTION:
Always set the knob fully to your desired mode
•
symbol. If you operate the tool with the knob
positioned half-way between the mode symbols,
the tool may be damaged.
Do not rotate the action mode changing knob when
•
the tool is running under load. The tool will be
damaged.
To avoid rapid wear on the mode change
•
mechanism, be sure that the action mode
changing knob is always positively located in one
of the three action mode positions.
Rotation with hammering
2
1
010158
1. Reversing
switch lever
runs
at
half
speed.
1. Lock button
2. Rotation with
hammering
3. Action mode
changing knob
3
For drilling in concrete, masonry, etc., depress the lock
button and rotate the action mode changing knob to the
symbol. Use a tungsten-carbide tipped bit.
Hammering only
1
010160
For chipping, scaling or demolition operations, depress
the lock button and rotate the action mode changing
knob to the
scaling chisel, etc.
Rotation only
1
For
010159
For drilling in wood, metal or plastic materials, depress
the lock button and rotate the action mode changing
knob to the
Torque limiter
The torque limiter will actuate when a certain torque
level is reached. The motor will disengage from the
output shaft.
When this happens, the bit will stop turning.
CAUTION:
As soon as the torque limiter actuates, switch off
•
the tool immediately. This will help prevent
premature wear of the tool.
Hole saws cannot be used with this tool. They tend
•
to pinch or catch easily in the hole. This will cause
the torque limiter to actuate too frequently.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the
tool.
5
1. Hammering only
symbol. Use a bull point, cold chisel,
1. Rotation only
symbol. Use a twist drill bit or wood bit.
Publicité
Table des Matières
