Makita AN902 Manuel D'instructions page 7

Pistolet clouer
Masquer les pouces Voir aussi pour AN902:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Nails
Handle nail coils and their box carefully. If the nail coils
have been handled roughly, they may be out of shape or
their connector breaks, causing poor nail feed.
Avoid storing nails in a very humid or hot place or place
exposed to direct sunlight.
MAINTENANCE
CAUTION:
Always disconnect the air hose from the tool before
attempting to perform inspection or maintenance.
Never use gasoline, benzine, thinner, alcohol or
the like. Discoloration, deformation or cracks may
result.
Maintenance of nailer
012343
Always check the tool for its overall condition and loose
screws before operation. Tighten as required.
012337
With tool disconnected, make daily inspection to assure
free movement of the contact element and trigger. Do not
use tool if the contact element or trigger sticks or binds.
012344
When the tool is not to be used for an extended period of
time, lubricate the tool using pneumatic tool oil and store
the tool in a safe place.
012345
Avoid exposure to direct sunlight and/or humid or hot
environment.
Maintenance of compressor, air set and air hose
1
004317
1
004318
After operation, always drain the compressor tank and
the air filter. If moisture is allowed to enter the tool, It
may result in poor performance and possible tool failure.
004319
Check regularly to see if there is sufficient pneumatic oil
in the oiler of the air set. Failure to maintain sufficient
lubrication will cause O-rings to wear quickly.
7
1. Drain cock
1. Air filter
1. Oiler
2. Pneumatic oil
1
2

Publicité

Table des Matières
loading

Table des Matières