Imit SILVER TA S Mode D'emploi page 12

ROOM THERMOSTAT WIRING DIAGRAM
HEATING/COOLING UNIT
Warning!
Operations within the heating / cooling unit or the electrical installation must be carried
out by professionally qualified persons.
ROOM THERMOSTAT TEMPERATURE CALIBRATION
Temperature sensors which are used in Room Thermostats are highly sensitive. You
may need to calibrate your Room Thermostat if you would like to get the same
temperature values with other thermometers in your living space. While your device is
turned off, press and hold the button for 3seconds.
Press the button until the " CAL" menu appers. In order to see the desired temperature,
set the temperature difference by turning the button to right or left. This value can be
arranged between "-8oC" and "+8oC".
To save the settings and exit, press the "On/Off" button until the device turns off.
Note: Recommended tempreture calibration is "0.0oC".
ROOM THERMOSTAT HEATING / COOLING MODES
Your Room Thermostat has heating and cooling modes. In order to switch easily
between heating and cooling modes:
While your device is turned off, press and hold the button for 3 seconds.
Press the button until the "FUN " menu appears.
You can switch between " HER" (heating) and "COO " (cooling) modes by turning the
button to right or left in the " FUN" menu.
To save the settings and exit, press the button until the device turns off.
The settings you have made have been saved. Once you turned on your device, it will
operate with the changed settings.
FACTORY SETTINGS RESET
You can reset your Room Thermostat to its default factory settings. This operation
resets the calibration setting and heating/coling modes to factory setting. To reset your
Room Thermostat to factory setting:
While your device is turned off, press and hold the button for 3 seconds.
Press the button until the "RST" menu appears.