Team kalorik TKG SFC 1005 Mode D'emploi page 7

ASSEMBLY:
CAUTION : Do not connect the appliance to the power supply until you have chosen and
attached an accessory.)
After use, unplug the appliance from the mains supply socket and press the steam button
to reduce the internal pressure sufficiently. Then you can release the safety lid.
1. Unscrew the safety lid. To do so, press the safety lid and at the same time turn it
anticlockwise (if there is still water in the tank and if the safety lid was still screwed in
tight for a previous use, some degassing will occur. This is normal and not dangerous).
2. Fill the water tank with water. Please use the provided measuring cup and the funnel.
(It is recommended that you fill the tank to max. 2/3 full.)
3. Note: never fill descaling agent, perfume or detergent into the water tank, in order to
avoid damages to the appliance.
4. Screw back the safety lid. To do so, press the safety lid and at the same time turn it
clockwise.
5. Put the desired accessory (flexible hose, nozzle, scrubbing brush etc.) on the
appliance: set the accessory on the connection in such a way that the opened
padlock  on the accessory is well aligned with the arrow on the appliance, then
press the accessory up to the rubber sealing and turn the accessory in the direction
indicated by the arrow on the accessory until the accessory is locked to the appliance
(and the closed padlock  of the accessory is well aligned with the arrow of the
appliance).
The brush and the curved nozzle can be assembled onto the connection, but also
onto the flexible hose or onto the straight nozzle.
6. Window wiper: CAUTION! Do not operate this appliance directly on cold glass.
7. The window wiper must be attached to the scrubbing brush. First assemble the
scrubbing brush onto the appliance or onto the flexible hose. Take off the cloth from
the scrubbing brush and connect the window wiper to the brush by the two hinges.
The window wiper can be dismantled easily by unhooking the hinges again.
OPERATION
1. Attach the appliance to the mains supply and the control lamp lights up. As soon as
the preheating (about 3-4 minutes) is terminated, the control lamp goes out.
Slide up the child lock security button on the top of the steam button and press it to
begin steam cleaning.
Slowly move the appliance over the surface to be cleaned. It is recommended that
the distance between the nozzle and the surface amounts to at least 2-3 cm.
The control lamp switches on and off during the process, according to the thermostat.
CAUTION! The appliance cannot be tilted over 45° during the operation. Never direct
the appliance towards humans, animals or plants.
2. Refilling the water tank :
Unplug the appliance from the mains supply socket. Press the steam button and
release the internal pressure completely. Wait approx. 3 minutes and release the safety
lid slowly. After the appliance has cooled down to approximately the ambient
temperature, fill the water tank up to 2/3 full. Please use the provided funnel and the
measuring cup. Close the safety lid and attach the appliance to the mains supply
again.
CAUTION! Before you release the safety lid, make sure that the internal pressure is
sufficiently reduced.
7
TKG SFC 1005