Publicité
Les langues disponibles
Les langues disponibles
Always wear SAFETY GLASSES
when installing hitch
1. Install receiver housing to hitch - a) Take the receiver and the weather covers out of case. b) Unlock the blue handle using key attached
and remove the housing from the receiver by pressing the blue handle and rotating clockwise until a click sound, as shown in Figure A, B,
washer ③ , and prevailing torque nut ④ , as shown in Figure E.
and C. c) Install the top/bottom weather cover to the housing, see Figure D. d) Attach the housing to the hitch using M12 bolt ②, flat
2. Keep the card ⑤ in the glove compartment. Peel off the label ⑥ and apply them on the top of the receiver
Tighten the fasteners for housing to 92 Lb-Ft (125 N*M).
and door jamb respectively, see Figure F.
Note: For receiver installation & use, see instruction 76900N with receiver kit.
A
CLICK
2
C
©2021, 2022 Horizon Global™ Corp - Printed in Mexico
Installation Instructions
PART NUMBERS: 76908
B
1
E
Proper torque is needed to keep the
hitch secure to the vehicle when towing.
Sheet 3 of 15
D
Representative
Brackets
②③
76908N
2-15-22
Rear
④
Rev. C
Publicité
