Kicker KM10 Manuel D'utilisation page 2

Authorized KICKER Dealer:
Purchase Date:
Subwoofer Model Number:
Speaker Serial Number:
MODEL:
Nominal Impedance [Zn] | ohm
Frequency Response | Hz
Power Handling | Watts Peak [RMS]
Sensitivity [SPLo] | dB @ 1W, 1m
Outer Diameter with Grille | in [cm]
Hole Cut-Out Diameter | in [cm]
Mounting Depth | in [cm]
INSTALLATION
Wiring: Carefully place the speaker wire
in a location that is clear of standing water
and moving components of the vessel.
The terminal cover is removable for wiring
installation, and when locked-in-place, it aids
in ignition protection. Connect the speaker
wire to the speaker terminals, then loop the
positive and negative wires up, back down,
then together, and up through the slot in the
terminal cover. See Figure 1.
Figure 2
Storage Space
2
2011 KM Sub RevB.indd 2 2011 KM Sub RevB.indd 2
KM10
Your KM subwoofer was specially
KM10
designed for "Livin' Loud" out in
the harsh marine environment. It
4
is magnetically shielded and uses
30-500
advanced materials and construction
300 [150]
techniques to maintain optimal
performance for years to come. The
86.5
KICKER KM subwoofer is designed
11 1/4 [28.6]
to be extremely versatile. The KM
9 5/16 [23.5]
subwoofer excels in a sealed or vented
5 1/4 [13.2]
box, and it surpasses the competition
in an infi nite baffl e (free-air) installation.
Figure 1
Infi nite Baffl e Mounting: The infi nite baffl e mounting
method effectively utilizes the storage space of
most boats. Use caution when mounting speakers
through any panel of the boat. Please be aware of
wiring harnesses, springs, hinges, and folding seat
mechanisms that may interfere with the operation of the
boat or speaker system. Mark the panel for the hole
cut-out diameter of the subwoofer and cut the hole.
See Figure 2.
KM10 Subwoofer
Owner's Manual
Terminal
Cover
Terminal
Cover Slot
1/27/2011 10:09:24 AM 1/27/2011 10:09:24 AM