Nuvo IRON SLP03 Instructions D'installation page 2

IMPORTANT
When you receive solar lights, switch to the "ON" position and then place the light cover upside
down on a table or flat surface to keep them in the darkness to check whether they light up or not.
Situation 1: If the light works, place it in a sunny area so it can absorb direct sunlight.
Situation 2: If the light doesn't work, reset the battery or allow at least 3 days and nights of
charging and draining for the battery to charge to its full capacity.
Problem 1: The night runtime for the lights is short.
Solution 1: It's likely the battery is not fully charged. Install the solar light in an area
where it can receive the maximum amount of direct sunlight.
Solution 2: It's also possible the battery is worn out. Replace the old batteries with
new ones.
Problem 2: The solar light does not turn on at night.
Solution 1: If it's close to other light sources, either relocate the solar light to a place
with direct sunlight or eliminate the other light sources if possible.
Solution 2: Reset the battery or allow at least 3 days and nights of charging and draining
for the battery to charge to its full capacity.
REPLACE THE BATTERY
1. Twist and remove the housing (B) from the top
cover (A).
2. Remove the battery cover and replace the old
battery with a new rechargeable battery.
3. Replace the battery cover and the
housing. (Fig. 1)
4. Recycle the used battery or dispose of it properly.
Do not puncture, short circuit or discard of in fire.
·
nuvoiron.com 1.866.955.0355
Decorative Glass Solar Pathway Lights
·
info@nuvoiron.com
#NuvoIron for a chance to be featured on our social media pages!
INSTALLATION INSTRUCTIONS
B
A
@nuvoironfencing @nuvoiron
SLP03
Fig. 1
@nuvoiron @nuvoiron