Publicité
Les langues disponibles
Les langues disponibles
Before operation, please read the operation manual carefully to know the
equipment the correct method of use. Please keep it for future reference.
SAFETY PRECAUTIONS
1. Before installation, please check the grid for single-phase 230 v ±10%
(50 Hz) or "three-phase" 400 v ±10% (50 HZ) ". Otherwise unable to use
it.
2. Detection of the charging device has the function of user network circuit
load capacity; When the electric grid circuit of the user cannot bear the
charging power of the charging device, the device will automatically reduce
the charging power and then charge the electric vehicle. This function can
solve the problem of frequent tripping caused by the user's grid voltage
instability, circuit aging and other problems; At the same time, it can reduce
the safety problems caused by the user's circuit problems. If the charging
power is reduced in use, it is a normal phenomenon.
3. This equipment has over-voltage, under-voltage protection; It also has
overload protection function. After the device automatically adjusts the
charging power, the device will automatically shut down the charging and
stop using if the user's grid voltage is still abnormal.
4. Install the equipment, the total input of the front-end must be installed
circuit breakers.
5. Do not use flammable, explosive, or combustible materials, chemicals,
combustible gas and other dangerous goods near the charging pile.
6. Keep dry and clean on the charging point. If there is any dirt, please use
a clean, dry cloth to wipe it. It is forbidden to touch the point pin.
- 2 -
Publicité
