Remington RM2510 Manuel De L'utilisateur page 8

INSTALLING THE CUTTING HEAD SHIELD
RM2510
WARNING:
To prevent serious personal injury, never
operate the unit without the cutting head shield in place.
1. Remove the wing nut and washer from the cutting head shield.
2. Insert the short tab (the one without a hole) on the mount
bracket into the slot on the cutting head shield (Fig. 1).
3. Rotate the cutting head shield counterclockwise to align the hole
on the cutting head shield with the hole on the mount bracket
(Fig. 1).
4. Insert the square bolt into the hole underneath the cutting head
shield (Fig. 2). Push the square bolt through the cutting head
shield and mount bracket.
5. Place the washer onto the square bolt (Fig. 2).
6. Screw the wing nut onto the square bolt until the cutting head
shield is firmly in place (Fig. 2).
INSTALLING THE CUTTING HEAD SHIELD
RM2560
WARNING:
To prevent serious personal injury, never
operate the unit without the cutting head shield in place.
1. Remove the wing nut and washer from the cutting head shield.
2. Insert the short tab (the one without a hole) on the mount
bracket into the slot on the cutting head shield (Fig. 3).
3. Rotate the cutting head shield until the bolt on the cutting head
shield protrudes through the hole on the mount bracket (Fig. 3).
4. Place the washer onto the bolt (Fig. 4).
5. Screw the wing nut onto the bolt until the cutting head shield is
firmly in place (Fig. 4).
ASSEMBLY
Cutting Head
Shield
Cutting Head
Shield
Square Bolt
Bolt
Cutting Head
Shield
Bolt
8
Slot
Fig. 1
Fig. 2
Hole
Fig. 3
Fig. 4
Mount Bracket
Mount Bracket
Wing Nut
Washer
Mount Bracket
Tab
Slot
Wing Nut
Washer