Henn&Hart FL0022 Mode D'emploi page 3

PRE-ASSEMBLY:
Carefully remove all parts and hardware from carton, along with any protective plastic packaging.
Do not discard any contents until after assembly is complete to avoid accidentally
discarding small parts or hardware.
F
G
H
I
J
K
STEP 1:
Begin with the Base (A) by placing it
upright on a flat, even floor surface.
Attach the Bottom Post (B), taking
extra care not to strip the threads.
Tighten firmly by hand.
Made in China
E
C
B
A
D
L
NOTE:
Use screwdriver
with the
preinstalled set
screw to adjust
and secure the
cord for lamp
shade position.
WARNING:
Only use the
supplied nylon
screw to secure
cord. To avoid
risk of shock or
damage, never
use a metal or
pointed screw.
Page 3 of 7
PARTS:
(A) Base
(B) Bottom Support Post
(C) Center Support Post
(D) Top Support Post
(E) Washer
(F) Thumb Screw
(G) On/Off Switch
(H) Cord/Socket
(I) Shade
(J) Shade Ring
(K) Light Bulb (not included)
(L) Screwdriver
For use with the following
types of light bulbs:
(not included)
• 100W Type A
• 2 3W Self-Ballasted
• 9W SB LED
DO NOT EXCEED THE
SPECIFIED WATTAGE