Package Contents; Safety Information; Preparation - Allen + Roth WSLW48IFVW Instructions D'assemblage

PACKAGE CONTENTS

C
A
B

SAFETY INFORMATION

Please read and understand this entire manual before attempting to assemble or install the product.
WARNING
Do not stand on vanity. Use vanity on level ground. Base vanity supports a maximum weight of 200 lbs. Exceeding maximum
weight limit will compromise the integrity of the vanity structure and could cause the vanity to fail.
CAUTION
Do not hang from the vanity.

PREPARATION

Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list and hardware
contents list. If any part is missing or damaged, do not attempt to assemble the product.
Estimated Assembly Time: 15 minutes
Tools Required (not included): Silicone compound.
PART DESCRIPTION
A Vanity Top (preassembled)
B Vanity Base
C Backsplash
2
ASSEMBLY INSTRUCTIONS
Step 1: Vanity Drawer Removal
QUANTITY
1a. Open the preassembled drawer as far as possible.
1
1b. Simultaneously press the right side spring clip downward and the left side
1
spring clip upward.
1
1c. Once both springs clips are held in the indicated position, pull the drawer
straight out.
Step 2: Adjustable Level
2a. In case of uneven floors, floor levelers are provided at the bottom of the
vanity. If necessary, adjust floor levelers by hand to correct tilting and/or
level doors.
Step 3: Backsplash Installation
3a. To mount the backsplash (C) to the wall, apply a thin bead of silicone
compound (not included) to the unpolished back side and bottom of the
backsplash (C). Position backsplash (C) as shown onto vanity top (A)
and against the wall. Clean any excess silicone compound before allow-
ing to dry.
1
2
3
C
3
Silicone
A