ARENDO DIVINE Mode D'emploi page 27

12. Troubleshooting
Possible Faults
The toaster does not
function
The toast is too bright
or too dark after
toasting
Smoke is emitted from
the toaster during
toasting
The toast is imme-
diately ejected after
toasting has started
The power cord is
damaged
13. Safety instructions and disclaimer
Please do not try to open the appliance to carry out repairs or modifications. Avoid
contact with the mains voltage. Do not short-circuit the product. The appliance is
not waterproof, therefore please use it only in dry surroundings. Protect it from
high humidity, water and snow. Do not expose the appliance to high temperatures.
English
Solution
Insert the mains plug into the power socket If there
is no improvement, have the appliance checked by a
specialist!
Select a different degree of browning.
• The degree of browning you have selected is too
high for the type of bread used. Immediately press
the "CANCEL" button to stop toasting.
• The toaster is dirty. A piece of toast has been
caught in the heating surfaces. Clean the appliance.
• The crumb collector is overfull and crumbs begin to
smoke. Empty the collector!
Ensure that you have engaged the slide switch
correctly in the lowest position. If the appliance still
ejects the toast in the same way at the next attempt,
please contact a technician or the manufacturer of
the appliance.
In this case, you should no longer use the appliance!
Contact an authorised technician or the manufacturer
of the appliance, in order to have the cable properly
replaced!
27