ARENDO DIVINE Mode D'emploi page 24

5
6
7
8
5. Commissioning and use
Connect the power cord to a properly wired power socket. First proceed as
described in Section "3 Commissioning".
Ensure that the power plug has been inserted. Insert up to two toast slices
into the toast slot. Turn the "rotary switch provided for adjusting the degree of
toasting" to the desired setting and press the "slide switch" down until it snaps in
place. The heating elements warm up and the toasting process begins.
Once the process is complete, the "slide switch" automatically jumps back to its
original position. This means that the toasting process has finished and the bread
slices can be taken out carefully.
If the degree of toasting is not satisfactory, adjust it using the "rotary switch pro-
vided for adjusting the degree of toasting" and repeat the toasting again. In this
case, ensure that the toast does not get burnt. If the desired degree of toasting
has already been attained, you may then end the process at any time by pressing
the "CANCEL" key.
6. Bread roll attachment
Bread rolls, baguettes and loaves are too large to place in the toasting slot. Always
use the bread roll attachment for this purpose. Place the bread roll attachment on
the toasting slots.
Note: Ensure that the crumb collector has been inserted correctly.
Before toasting on the bread roll attachment, ensure that the toaster has cooled
down completely. Ensure that no toast has been inserted into the "toast slot"
when using the bread roll warming rack, as otherwise this can result in fire.
24
Crumb collector
Slide switch
Toast slots
Bread roll attachment
English