GE 42 Manuel D'utilisation page 37

11 INSTALL DOOR PANELS
WITH PRE-INSTALLED HANDLES
Install 1/4" Decorative Panels:
• Remove Handles
Open door to 90°. Remove 5 Phillips head
screws from the Fresh Food and Freezer door
handles; retain all screws. Lift off door handles.
• Install Door Panels
NOTE: Carefully push the Fresh Food panel in until
it slides into the slot behind the trim. Gently push
to opposite side. Repeat procedure for upper and
lower Freezer panels.
• Reinstall Handles
Reinstall Fresh Food door handle with
the original 5 Phillips head screws. Tighten.
Repeat for Freezer door handle.
NOTE: Ensure that the edge of the handle does
not pinch the door gasket.
• 3/4" Custom Decorative Panels
If you choose to install custom wood panels,
they must be cut to dimensions shown on
pages 23–30. The panels will slide into the
frame on the doors and grille.
IMPORTANT NOTE: Maximum custom panel
thickness must not exceed 1-1/8" thick and 70 lbs
for the Fresh Food door, 45 lbs total for the Freezer
door and 15 lbs for the Grille panel.
Installation Instructions
37
Handle
Fresh Food
Refrigerator
Door
3/4" Custom Panel
if Required