Publicité
Les langues disponibles
Les langues disponibles
STEP 5
Re-fit the Sunroof Deflector centrally onto roof. Position
the clips at the front end of the sunroof opening. Depress
the end of the Sunroof Deflector to hook the clips under
the inside edge of the opening. See FIGURE 5
STEP 6
Using a phillips screwdriver and a spanner, start to tighten
one end while at the same time applying pressure to the
top front corner near the screw to ensure the rubber gasket
is flat against the roof surface and not curling under itself.
Repeat process on the other side. See FIGURE 6.
STEP 7
Push down on the rubber gasket with your thumb along
the entire length to seat the rubber gasket correctly with
the roof surface as shown. See FIGURE 7.
TO REMOVE: Reverse above procedure.
IMPORTANT: Retain installation instructions for future
use.
Do not use abrasive cleaners.
5
6
7
Clean Sunroof Deflector with a mild
detergent and water solution.
SG562b
2/6
K6859751
Publicité
