Led Status - Kobalt KRC 30-06 Manuel D'instructions

SAFETY INFORMATION
IMPORTANT SAFETY INSTRUCTIONS
instructions.
•
• Do not allow liquid inside the charger.
• Do not try to use the charger for any other purpose than what is presented in this manual.
• Do not cover the ventilation slots on the top of the charger. Do not set the charger on a soft
surface, i.e. blanket, pillow. Keep the ventilation slots of the charger clear.
• Do not allow small metal items or material such as steel wool, aluminum foil, or other foreign
particles into the charger cavity.
OPERATING INSTRUCTIONS
1. Charging procedure
Plug the charger into an AC power outlet.
• Insert the battery into the charger. A fully discharged
battery pack will require approximately 30 minutes
(2Ah) to fully charge from a discharged state.
This is a diagnostic charger. The charger LED lights will
battery status. They are as follows:
Charging
Charged

LED STATUS

Blinking Green
Solid Green
Solid Red
Blinking Red
False defect note:
When the battery is inserted into the charger and the status LED blinks RED, remove the battery from
the charger for 1 minute, then reinsert. If the status LED blinks GREEN, then the battery is properly
charging. If the status LED is still blinking RED, remove the battery and unplug the charger for
1 minute. After 1 minute, plug in the charger and reinsert the battery. If the status LED blinks GREEN,
then the battery is properly charging. If the status LED is still blinking RED, the battery is defective
and needs to be replaced.
Battery storage:
If the battery will not be used for 3 months or more, please store the battery in a room temperature
environment. Please fully charge before storage.
Low voltage charging:
If the battery has been stored with little to no charge for a long period of time, the charger will go into
recovery mode, which will take 20 hrs to fully charge the battery. This will enhance the life of the battery.
Once it is fully charged, the next charge will return to standard charging.
Fully Over Charging
Temperature
DESCRIPTION
Charging
Fully Charged
Over Temperature
Charging Fault
1
Fault
3
kobalttools.com