Re-Assembling After Activation - Held Air Vest Manuel D'utilisation

5. Re-assembling after activation

Before re-assembling check for any external damage and have a new cartridge ready to be
screwed in. If you are unsure of the correct procedure to reset your airbag we recommend you
take it to an authorised dealer for resetting. The vest can be reused if it is reset according to the
following procedure, but if it is not reset correctly there could be a malfunction.
Scheme:
CO2-Cartridge
Plastic cylinder
Piston
A.
Position of the trigger after the activation: the ball is out of
its set, the piston has slid towards the cartridge and the
spring is visible.
B.
Unlock the cap with the 5mm allen wrench supplied with
the jacket. You can use your fingers at some point. Do not
unscrew the cap completely. 12mm out of the cylinder is
enough.
C.
Unscrew the CO2 cartridge and remove it. This canister
may not be reused and must be replaced with a new one.
Key-Ball
Spring Cap
GB
13