Clock Setting - Orbis Orus Manuel D'utilisation

INITIAL START-UP / RESET
• Insert the battery and press the "R"
key using a point.
All the display segments will turn
on and the relay will be activated for
3 seconds; after this, the clock field
(22) will start at 12:00 and will flash
until the clock is set.
Attention
if the clock is not set,
the programmable thermostat
will not adjust; it will start doing
so only once the clock is set.
• Press the " " key; on field (16)
seconds will run flashing, while field
(22) will display digits for minutes
and hours.
Press the " " key to reset seconds
and increase the minute field by 1 or
" " to reset the seconds field.
Press the " " key to confirm.
(In case the setting of the clock takes
place after a reset, the "seconds" field
is not adjustable. Therefore, the first
parameter to set will be the "minutes"
field).

CLOCK SETTING

- 39 -
Orus Programmable Thermostat User Manual