Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Heating cable connection
Cut off heating cable ensuring a straight cut and slide
on threaded cap 3 and clamping sleeve 4.
Pare back the protective cover on the heating cable by
42 mm. Slide clamping sheet 5 over the metal
jacketing (braiding) right up to the protective cover.
Draw the metal jacketing (braiding) back over the
clamping sheet.
Before inserting the heating cable into the
!
sleeve, ensure that the tip of sleeve 6 and the
groove of the clamping sleeve 4 are aligned.
Insert heating cable into sleeve 6 until the heating
cable is flush with sleeve 6.
Reservation
We reserve the right to make technical changes. Changes, mistakes or print errors do not justify any claims to damages.
1
42 mm
2
3
right
wrong
Push clamping sleeve 4 against sleeve 6 and insert into
the relevant housing in your packing (1, 2 or 7).
Ensure that the tip
and groove
antirotation key are aligned.
Screw together threaded cap 3 and the
!
appropriate housing (1, 2 or 7) until the stop
is reached.
Heating cable termination
Cut the heating cable off straight.
Take 20 mm off the protective cover and metal
jacketing (braiding) on the heating cable.
Shorten the bared heating cable to 5 mm.
5 mm
Insert the heating cable to its full extent into
terminal 8.
Tool
4
of the
5
6
Publicité
Table des Matières
