FONtevo COMpact 4000 Notice D'utilisation page 48

Installation
ISDN Terminals at the Internal S
Connection possibilities:
• System telephones COMfortel 1200/1400/1600/2600 (firmware version 1.6A or later)
• ISDN telephones in accordance with the Euro ISDN Standard (DSS1)
• ISDN PC controllers in accordance with the Euro ISDN Standard (DSS1)
Important: For COMfortel 1400/2600 with answering machine: In order to ensure that the full
scope of functions is available, you should connect only 1 telephone per port.
Requirements:
• Enabled operating mode "S
• Enabled terminators in the PBX at the internal S
in two directions)
operating mode "S internal"
0
If PBX and terminal have a
short distance to each other,
make the connection with an
ISDN cable (max. 10 m) at the
RJ-45 sockets of the internal S
port.
If the distance between PBX
and terminal is greater, lay the
lines fixed at the terminal
clamps of the internal S
48
Port
0
internal" at the S
0
0
port.
0
port in question
0
port in question (exception: bus wiring
0
terminators enabled
internal S port
0
IAE/UAE8
terminators
100 Ohm, 0.25 W
COMpact 4000 Instructions V04 03/2017