Imusa B120-60006 Manuel D'instructions page 9

•
Remove all packing material and stickers from the product and save instruction manual.
Caution: Tear up all plastic bags as they can pose a risk to children.
•
Cut and remove tie wrap located between the electric plug blades.
•
Before using your new appliance, wipe the body of the appliance with a damp cloth.
•
Wash all the removable parts with warm sudsy water. Rinse and dry thoroughly.
•
Place appliance on a flat stable surface.
Caution: Because some countertop finishes are more sensitive than others, use care not to place
espresso maker on surfaces where heat may cause damage.
•
Make sure switch is in the OFF position (0).
•
Check that the coffeemaker is not hot, and unscrew it by holding the boiler with one hand and
turning the pitcher counterclockwise with the other.
•
Remove funnel and fill the boiler with fresh water until reaching the safety valve (visible inside
the boiler) without filling past it.
Note: Do not use the coffeemaker without water in the boiler. Also do not put hot water in the
boiler for faster operation.
•
Insert the funnel in the boiler.
•
Tighten the coffeemaker securely. Hold the boiler with one hand and turn the pitcher clockwise
with the other hand, without pushing on the handle.
•
Place the coffeemaker on the base. Close the lid.
•
Plug into a standard 120 Volt AC outlet.
•
Press the switch ON (I). The light will indicate that the coffeemaker is on.
Caution: Do not open the lid to the pitcher during the brewing process as scalding may occur.
•
Brew the water through the appliance without adding coffee grounds. This removes any dust or
residue that may remain in the system from the manufacturing process.
•
The water will start to be released after a few minutes.
•
When brewing stops, press the switch OFF (0).
•
Unplug unit and allow the coffeemaker to cool.
HOW TO USE YOUR COFEEMAKER
•
Make sure switch is in the OFF position (0).
•
Check that the coffeemaker is not hot, and unscrew it by holding the boiler with one hand and
turning the pitcher counterclockwise with the other.
•
To prepare 6 cups of coffee, remove funnel and fill the boiler with fresh water until reaching the
safety valve (visible inside the boiler) without filling past it. Insert the funnel in the boiler, and fill
the funnel with ground coffee without compressing it.
•
To prepare 3 cups of coffee, fill the boiler with water to around 2 centimeters below the safety
valve. Insert the 3-cup adapter in the funnel and fill the funnel with ground coffee without
compressing it.