Care And Cleaning - Imusa B120-60006 Manuel D'instructions

Note: Do not use the coffeemaker without water in the boiler. Also do not put hot water in the
boiler for faster operation.
•
Distribute the ground coffee uniformly and remove any excess coffee from the edge of the filter.
Note: Use good quality, medium ground coffee.
•
Tighten the coffeemaker securely. Hold the boiler with one hand and turn the pitcher clockwise
with the other, without pushing on the handle.
•
Place the coffeemaker on the base. Close the lid.
•
Plug into a standard 120 Volt AC outlet.
•
Press the switch ON (I). The light will indicate that the coffeemaker is on.
Caution: Do not open the lid to the water reservoir during the brewing process as scalding may
occur.
•
The coffee will start to be released after a few minutes.
•
When brewing stops, press the switch OFF (0).
•
Unplug unit and allow the coffeemaker to cool.
-----------------------------------------Page break----------------------------------------

CARE AND CLEANING

This product contains no user serviceable parts.
•
Unplug the cord and wait for the appliance to cool completely before cleaning.
•
After each use, the pitcher, boiler, funnel and adapter, should be emptied and rinsed thoroughly
with warm water. Make sure to completely dry the boiler and store it unassembled to avoid any
moisture build up inside the boiler. Take care not to wet the electrical parts. Never rinse the
boiler or base directly under the tap water and never immerse it in water.
Note: Make sure all the parts are properly installed before each use.
•
Clean inside of the central tube periodically.
•
Regularly check the gasket. Replace if there are signs of wear or deterioration. Use original spare
parts only.
•
Every so often, check for any blockage on the disk filter. Blockages may be removed by using a
pin or needle as illustrated below.
•
Never immerse the appliance in water or other liquids.