Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EUROPE
8. FOLDING YOUR ROLLATOR
FIG. 1
FIG. 2
9. ATTACHING/REMOVING THE STORAGE BAG
FIG. 1
FIG. 2
10
If footrests are installed on the rollator,
flip up footplates and swing away footrests
before folding.
Any content in the storage bag should be
removed to ease the folding process of the
rollator and prevent any damage to items.
Pull the seat strap (when available, the red tag
indicates where to pinch and pull) and pull
upward (FIG.1) until the rollator locks in folded
position (FIG.2).
To remove the storage bag, fold the rollator
slightly (FIG.1) and slide bag out of receptacle,
pulling on both ends (FIG.2).
To replace the bag, reverse above steps.
The SWL (safe working load) is
10 lb (4.5 kg).
10. CUP HOLDER INSTALLATION
Installing the cup holder (reversible left or right)
FIG. 1
requires no tools. Simply clip it below the handle on
the opposite side of the cane holder (FIG.1).
Adjust the cup holder direction according to your
preference (FIG.2).
The cup holder SWL (safe working load)
is 3 lb (1.3 kg).
FIG. 2
11. CANE HOLDER INSTALLATION
Installing the cane holder (reversible left or right)
requires no tools. Simply clip both cane holder's parts
to the same side.
Clip the upper part underneath the handle (FIG.1).
Clip the bottom part above the brake or above the
front wheel (FIG.2).
FIG. 1
For proper cane alignment once clipped, both parts
can be rotated to desired angle (FIG.3).
The cane holder SWL (safe working load)
is 3 lb (1.3 kg)
FIG. 2
FIG. 3
- OWNER'S MANUAL
(NOT COMPATIBLE WITH ARMRESTS)
1 1
Publicité
Table des Matières
