Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
3/ Operation
Press MENU to display the setting menu interface.
Press
/
or.
setting or Window detection function.
flash and the other icons will remain lit.
Press MENU to exit the setting menu or wait 30 seconds for the
unit to automatically exit and return to the operating interface.
3.1/ Setting the time and day of the week
- Press MENU to enter the setting interface, and
the time setting.
When the time display 12:00 flashes on the top right of the
screen, press OK to start the time setting. Press
between day of the week, hours and minutes, and
day of the week, hours and minutes.
- When the hour digit is flashing, press
press OK to confirm the hour setting and go to the minute setting
from 00 to 59.
- When the minutes digit is flashing, press
and press OK to confirm the minutes setting and go to the day setting.
confirm the minute setting and move to the day of the week setting
from 1 to 7.
- When the day digit flashes, press
and press OK to confirm, or after 30 seconds, you will automatically
return to the operation interface.
3.2/ Select the mode (buttons
The first time you use the device, after connecting it to the power
supply and setting the clock, the device is in standby mode, and you
can press the standby button to switch to comfort mode.
NOTES: In case of a power failure, the unit will store only the set-
tings, temperature and operating mode. When the power is restored,
the clock must be reset for. When power is restored, the clock must
be reset to allow normal use of the program mode.
Press
/
to switch between the modes: Comfort
gram
mode or Pilot wire
selected mode appears on the lower part of the screen.
The Program and Pilot Wire modes use the same icon
modes are mutually exclusive.
When the unit is operating in the Program mode, press and hold the
OK button for 3 seconds to switch from the Program mode to the Pi-
lot Wire mode. When the device is operating in the Pilot Wire mode,
press the OK button for 3s to switch from the Pilot Wire mode to the
Program mode.The interfaces of the Program and Pilot Wire modes
are as follows:
to select 12:00 timer setting, Program mode
/
/ Frost protection
. The selected icon will
/
to select the hour and
/
to select the minutes
/
to set the day of the week
/
)
30
/
to select
/
to toggle
/
to set the
/ Eco
/ Pro-
, the icon of the
. And the 2
Publicité
Table des Matières
