WATTZ PROFESSIONAL DEVA WZ1665 Manuel D'utilisation page 26

1
- Before installing the unit, check the condition of the wall to which it
will be attached: the wall must be in good condition, it must not show
any damage (cracks, sagging, moisture, ...).
Do not drill a hole near old holes, even if they have been filled in.
IMPORTANT! Make sure that there is no electrical wiring or any other
installation (e.g. water pipe) near the locations where the holes will be
drilled. Be sure to mount the unit vertically and firmly to the wall.
Drill the wall with a drill bit sized for the anchoring system. Remove
debris and dust. Regularly check the unit's mounting points on the
wall. Tighten them if necessary.
2/ Mounting
1-Loosen the mounting screw on the bracket without uns-
crewing it completely. Slide the metal latch out of the hole. Remove
the bracket by pulling it down.
2-Position the wall mount in the desired location. Use a spirit level
to ensure that it is horizontal. Mark the location of the 4 screws to be
used to fix the wall. Drill holes in the wall to attach the appropriate
anchoring system. Attach the bracket to the wall.
Roof/Tablet
Floor
26
Choose a suitable
location for the heater
(respect the minimum
distances)