BATTERY MAINTENANCE
The AD-433S Dial-Alert comes with 1 battery that at some point you may have
to replace:
is working.
Dial-Alert Battery
The Dial-Alert comes equipped with a 9V backup battery in case the elec-
trical power is interrupted for any reason.
When the dialer backup battery is low, the LOBATT. light goes on.
To replace the dialer backup battery:
1. Undo the two screws on the back of the
Dial-Alert.
2. Open the Dial-Alert case by pressing
down on the two tabs on the top edge
and pull the front forward.
4. Connect the new battery.
5. Close the Dial-Alert case and re-insert the
two screws.
The battery life, (9 volt alkaline battery), is approximately two years if used
only for backup.
Note: If the AC adapter is disconnected while the battery is being replaced,
the pre-recorded message will be erased, and the clock will return to 12:00.
Re-record the emergency voice message and reset the clock. (Refer to page 10).
The pre-programmed phone numbers will not be erased even the power is
disconnected.
–
–
23
ADDITIONAL ACCESSORIES
Additional sensors and transmitters as well as add on accessories are available
to work with your Dial-Alert.
Motion Sensor (PS-433A)
- Monitors area in a 110 degree ARC and up to
40 feet away from the sensor
- 9V alkaline battery included
Door/Window Sensor (WT-433)
- Attaches to all doors, windows, entrances
- Add on as many magnetic switch (MS-001) as
needed
- 12V alkaline battery included
Magnetic Switch/Magnet (MS-001)
- Used in conjunction with Door/Window Sensor
(WT-433)
- Add on for additional doors, windows
Keychain Transmitter (4B-434)
- Activates Security Control Panel (SC-001) instantly
by pressing panic button
- Arm/Disarm Security Control Panel (SC-001)
- Reliable design, crystal base transmission with
microcontroller
- 12V alkaline battery included
Audio Alarm (AA-433)
- Additional indoor/outdoor siren
- Water resistant
- 120 dB siren with flashing LED
- Operates by AC adapter with 9V alkaline
back up battery (included)
–
–
24