Removing The Door - Inventum TK010 Manuel D'utilisation

3. Touch the function button to select the pyrolysis function. The oven indicator shows the pyrolysis mode.
4. Touch the start/pause button to start the pyrolysis function.
When the pyrolysis finishes, you will hear a continuous sound signal. Push the start/pause button to stop the
sound signal.
Pausing the pyrolysis function
1. Touch the start/pause button one time to pause the function.
Note:
You can open the door when the appliance is cooled down.
Stopping the pyrolysis function
1. Touch the cancel button to stop the function.
Note:
You can open the door when the appliance is cooled down.
Finish the pyrolysis
Warning:
Make sure that the appliance is cooled down.
1. Remove any pyrolysis residue. Use a damp cloth.

REMOVING THE DOOR

Warning:
Risk of injury. Keep your hands away from the hinges.
1. Open the door (A) of the appliance.
Caution:
Do not use a sharp object to open the levers. This can cause damage to the appliance.
2. Open the levers (B) on each side of the door.
3. Close the door halfway.
4. Remove the door. Use both hands.
5. After cleaning, install the door again. Refer to section
INSTALLING THE DOOR
Warning:
Risk of injury. Keep your hands away from the hinges.
1. Carefully place the door (A) in the appliance.
Caution:
Make sure that the hinges are placed correctly. If the hinges are placed incorrectly, you cannot open
the door.
2. Open the door.
'Installing the door'
.
(Figure 11)
(Figure 12)
English • 41