Operation - DeWalt DXGST227CS Manuel De L'utilisateur

HOLDING THE UNIT
WARNING:
risk of injury when operating this unit.
WARNING:
while operating the unit. The engine may be extremely hot.
• Stand in the operating position (Fig. 17). Stand up straight. Do not bend over.
• Keep feet apart and firmly planted.
• Hold the shaft grip with the right hand. Keep the right arm slightly bent.
• Hold the handle with the left hand. Keep the left arm straight.
• Hold the unit at waist level.
• Position the cutting head a few inches above the ground.
ADJUSTING THE TRIMMING LINE LENGTH
This unit is equipped with a bump head. Trimming line can be released from the cutting head without
stopping the engine.
To release more line, lightly tap the bump knob on the ground (Fig. 18) while operating the unit at high
speed. For best results, tap the bump knob on bare ground or hard soil. Attempting to release line in
tall grass may stall the engine.
NOTE: Do not rest the cutting head on the ground while the unit is running.
Each time the bump knob is tapped, about 1.5 inches (38 mm) of trimming line is released.
NOTE: Always keep the trimming line fully extended. Line release becomes more difficult when the
cutting line gets shorter.
A blade in the cutting head shield will cut the line to the proper length if any excess line is released.

OPERATION

Always wear eye, hearing, hand, foot and body protection to reduce the
To prevent serious personal injury, avoid arm contact with the engine
Fig. 17
25