Publicité
Les langues disponibles
Les langues disponibles
4
Change the driver, the LEDGINE module and the globe
CAUTION: CUT THE POWER SUPPLY BEFORE OPENING THE LUMINAIRE
2
E
8
4
D
7
C
B
A
REPRESENTATION ONLY
DESIGNER:
DATE:
TLD
02-25-16
VÉRIF./INSPEC.:
DATE:
4
3
8
1
3
TITRE/TITLE:
INS AS LUM RNS BILINGUE STD LEDGINE
FEUILLE/
NO DESSIN/
2 DE 2
5013135401
SHEET:
DRWING #:
3
Release the latch to open the luminaire.
5
Free the security cable from the ring to be
able to remove the driver support and the
frame #1.
6
To replace the driver #3, disconnect the
connectors and unscrew the two screws #2.
To replace the globe #4, remove the four
screws #5 and the driver support #6.
CAUTION, the globe will be loose beetween
the driver support and the frame #7.
To replace the LEDGINE module, follow the
steps to replace the globe.
Remove the three screws #8 and the
springs for every LEDGINE module. Remove
the black and red wires at the end of the
LEDGINE module and remove the module.
If necessary, clean the contact surface to
have a good heat transfer.
Install the ledgine module.
Reinstall the screws #8 and the springs.
Tighten the screws #5 at 11 lbs.in.
WARNING, if torque not respected, the
glass may break.
Install the globe #4 and the componant #6.
Inside the luminaire, install the connector
and plug the connectors.
2
REV.
ANNOTATION
THREAD INTEL
2
1
DATE
PAR/BY:
E
D
C
B
A
1
Publicité
