Member's Mark 720-0778A Consignes Pour L'assemblage Et L'utilisation page 36

Natural Gas Conversion for Model#
Searing Side Burner Conversion
Tools required:
The step-by-step instruction for converting the searing side burner's orifice are stated below.
1. Remove the screw under C bracket to take off the C bracket, then remove 4 screws at each corner of the
searing side burner and one screw for igniter.
2. Remove the searing side burner LP (Liquid Propane) orifice with 6mm driver, then Replace the NG
(Natural Gas) orifice to the connector by hand from beneath of side burner, then replace the side burner
to the original position, tighten screws for all corners.
Phillips Head Screwdriver (+)
6 mm Nut Driver
720-0778A
36