Product Description And Applications - Mhouse RT3 Instructions Et Avertissements Pour L'installation

1 Warnings
• MHOUSE disclaims responsibility for any damage resulting from
uses of the product other than those described in this manual.
• Protect the product's internal components from contact with
water and other polluting substances. Keep it away from heat
sources and do not expose it to open flames. If any of these con-
ditions occur, stop using it immediately and call MHOUSE cus-
tomer service.

2 Product description and applications

The RT3 kit consists in a TX3 transmitter and RC1 receiver, and
enables the user to control single-phase asynchronous motors
powered by electrical mains, with connections such as "COM-
MON", "OPEN" and "CLOSE". The RT3 is used for automations for
awnings, rolling-shutters and similar devices.
The RC1 receiver (fig. 1) operates at a frequency of 433.92 MHz
with rolling code technology thus ensuring high safety levels. Each
receiver can memorize up to 30 transmitters of the "TX3" (fig. 2) or
"TX4" (fig. 3) series.
After each command of the transmitter, the motor is powered for
the operating time required (factory setting approx. 150 sec). A lim-
it switch incorporated in the motor stops the movement when the
desired position is reached.
3 Installation
The RC1 receiver must be connected between the power supply line
(electrical mains) and the motor which is to be controlled, as shown in Fig-
ure 4.
WARNING: The electrical systems must be set up by qualified
and experienced personnel in compliance with current legis-
lation.
Can be separated, the RC2 box must be positioned where it
is inaccessible to the general public. Said box does not guar-
antee protection against access to those parts of the system
which are live.
If the RC1 receiver is installed outdoors, bear in mind that the
cable holders are only waterproof for round cables with a
diameter of 6.5 to 8.5mm.
1 Make sure there is no voltage anywhere in the electrical circuits.
2 Open the container of RC1 by removing the "cable cap" as
shown in the figure below.
2 RT3
Fig. 4
Fig. 5
• Disconnect the power supply before proceeding with the instal-
lation operations.
• The packing materials must be disposed of in compliance with
local regulations.
Fig. 1 RC1 Fig. 2 TX3
3 Strip the cable coming from the power supply line and the motor
cable about 15 cm and then the single wires approx. 5 mm
4 Thread the two cables through the designated holes in the "cable
cap".
5 Pull the card a few centimetres out.
6 Connect the conductors to the terminals as shown in fig. 8,
observing the diagram in fig. 13.
Fig. 3 TX4
Fig. 6
Fig. 7
Fig. 8