Bercomac 700524-1 Feuille D'instructions page 2

Instruction Sheet
BATTERY SUPPORT WITH WIRING #700524
INSTALLATION
Drill two holes (item 1) in the snowblower frame with
a 9/64'' bit.
Secure in place the strap supports (item 2) with four
flat head machine screws #6-32 x 3/4'' (item 3) and
four nylon insert lock nuts #6 (item 4).
(Do not use the screws supplied in the bag of the
strap).
Thread the strap through the supports to secure the
box for the battery.
Install the strap supports
Place the box for the battery (item 1) in the middle of
the support (item 2) and insert the battery (not
included).
Connect the engine's starter to the battery with the
red and black wires supplied. Be sure to use the
rubber tab insulation provided in the kit to protect the
positive terminal in the engine.
Put cover on the box and tighten in place with the
strap (item 3)
For the Versatile Plus and Prestige snowblowers:
Pass the red and black wiring thru opening A and D.
Be sure to secure the wires with tie-wrap at point A, B
and C. Ensure that wires never come into contact with
any moving parts of the blower.
For Versatile et Vantage snowblowers:
Take care to attach the excess wire with nylon tie-
wrap provided.
Install the box for the battery
FI_700524-1_EN M-11